Search results

Yes, sorry for the long delay, I'm very backed up with things I need to finish, but work on the 5.5.0 update is underway. There's a lot of stuff that's going in to it, from new device support, to bug fixes like your requested fix, and some needed MacOS compatibility fixes. I'm getting it done as...

As Mario said, it's been tricky - more issues than I'd expect. However, Apple has backed off their stance on compatibility, you can run it on Golden Gate. I just installed it on one of my Macs and the current editor runs on it with no issues I've seen.

Try turning off "Start up on last preset", then restarting the GT.

Good idea! You could do that using a MIDI app and MIDI Receive Channel on the Mastermind, but you're right that doing it directly from the editor would make sense. I can't make any promises, I'm so far behind on everything right now it's crazy. But I will keep it in mind.

Thanks! I appreciate it!

I'm happy to add it, but in typical Boss fashion, they don't list CC numbers in the manual, only the names. If you can take a look at the CC number list in the setup menu and post it here, I can add it to the next release.

Yes, thanks very much for that! Until we get sysex support from Fractal, I'll make up my own CC numbering scheme like I did for the VP4. It will be in the next release (which is in progress, but tied up with the ongoing MacOS 27 issues)

Are you sure about that? I designed a MIDI circuit for Reinhold a couple of years ago, and I think it was supposed to go into that amp. If I recall correctly, CC80 should select channel 1, CC81 channel 2, CC83 channel 3. The first non-channel switch would start at CC84 or CC88. Which CC does...

I think the problem here is that he's selecting banks on the PBC, and never using MIDI bank messages to select a bank. When a PC is received, it uses the last received MIDI bank message(s) and the newly received PC to figure out where to go. Changing the bank on the PBC itself doesn't affect the...

There's some overlap between iPad compatibility and Apple Silicon compatibility, both require newer development tools. But mostly, the issue with the iPad editor is that the UI has to be 100% rewritten to make sense on a touch screen.

If you turn on MIDI Bank Selects Song and also Use Song Index, then MIDI bank will select song number (or position within the setlist, if using a setlist). PC number will no longer select a preset by number but instead will select by index. PC0 = first preset in current song, PC1 = second preset...

Great news! The amount of work to transition an app over can be pretty substantial, as I've found. I bet there was a lot of pushback from app developers which caused them to push the date out.

Can someone send me a list of all the CCs on an AM4? I can't find them online, so the setup menu (or an editor app) is probably the only place to find them.

If there are a lot of messages, then you could by keeping the PBC too busy. It has to look at every incoming MIDI message and decide what to do with it. What messages are being sent, and how often are they sent?

That definitely would require new hardware, I wish it were otherwise!

I'm not in a location to test this either, but it might be by design that the two controllers don't sync to the same page. If I remember correctly, some techs wanted to be able to go to other pages and change things without the player's controller doing weird distracting things. I suspect if you...

Not sure, been quite a while since I did anything with that code.

Unfortunately you can only drag buttons within the same page, I didn't catch that you were trying to move them to a different page.

That's the difference - dragging buttons works, cut and paste doesn't. It's something that should be fixed for sure.

Dragging an IA button in the Buttons tab will move the saved per-preset IA states to the new button location.