Mini Amp Gizmo Question

Bolt Vanderhuge

New Member
Let me just state right off the bat that I am a midi noob. I don't know a whole lot about it but I have a question about controlling the multiple functions of my Fortin Bones. It seems that the assigned functions to the specific buttons are fixed is that correct? But when I switch say the gain switch while the Mini Amp Gizmo is plugged in, these assignments change. Is finding out what button controls what function just a trial and error thing?

One last question. If I had to buy a new midi interface for my Fortin what would I be looking at? In case the mini amp gizmo ever bites the dust.
 
I assume you have the manual for the Mini Amp Gizmo but if not let me know and I can provide you with a PDF copy.

Buttons 1 to 8 control the switching associated with pins 1 to 8 of the multi-pin DIN connector. Assignment of what pins 1 to 8 control on amplifiers depends on the specific amp, and the cable (often custom) that connects the Mini Amp Gizmo to the amplifier. Though the Mini Amp Gizmo is discontinued, custom cables for it are still available through BTPA.COM. Normally there's a single page included with any custom cable that indicates what the assignments are for the specific amp that the cable and Mini Amp Gizmo are controlling.

You should be able to find a used Mini Amp Gizmo if yours ever calls it quits. They are made with common parts so if something were to fail it could more than likely be repaired. Worse case scenario you could consider this https://voodoolab.com/product/control-switcher/
 
thank you so much Mario. That was very helpful. One follow up. Is there a definite pin to button assignment on the mini amp gizmo? the reason I ask is because I'm going to open the amp up and back track the function from the button to the circuit board on the amp that feeds the 10 pin connector on the amp. I have the cable already that goes from 8 pin Gizmo to 10 pin amp.
 
Back
Top