Question about Mission SP1-RJM implementation

Jstrings

Member
I'm using the Mission SP1-RJM expression pedal to control 4 different pedals via an Old Blood Noise Endeavor MIDI to Expression Translator (MTET) with my PBC/6X.

What I'm trying to figure out is if there is a way to configure the toe switch on the SP1 to functionally act as an on/off switch for each given effect I'm controlling with the MTET.

Is there a way to configure the ext/toe switch to do something that will get me there? I'd need the MTET to stay parked at a different value for "off" depending on which pedal I'm controlling with it.

Is this in the realm of possible? I'm a bit technically challenged and struggling...
 
Last edited:
You can use the expression pedal Position Switch Actions and/or the built-in momentary switch on the SP1-RJM to turn things on and off. Below is some info to get you started if you need it, but I think you're beyond that. If so, to turn different things on and off with the expression pedal, I believe you could use Action > System > Macro and then select which Macro to use for the ON/OFF functionality. Using Macros would allow the expression pedal to turn different things on and off based on which Macro(s) the expression pedal utilizes depending on what's been programmed as part of every Mastermind preset.

For example, every Mastermind preset has an Expression Pedal Override where you can tell it which Macro(s) to use for that preset. Alternatively, you could also use Expression Pedal Blocks to do the same thing.


Position Switch Actions​

The expression pedal port has a position switch that can trigger Actions when the pedal goes above or below a certain position. This is separate from the built-in toe switch found on the Mission Engineering SP1-RJM pedal, which works as an External Switch and is edited using the Button Edit Page. You can use both the position switch and the toe switch at the same time if desired.

The actual position at which the switch happens has to be programmed on the Mastermind GT or PBC, using the Set Switch Position option in the Expression Pedal menu. The action list can be edited on this page using the standard action editor.

Invert Position Switch - When this checkbox is not checked, the position switch is considered to be on when the pedal is between the switch position you specified and the heel up position. The position switch is considered to be off when pedal is between the specified switch position and the heel down position. When this checkbox is checked, it's reversed: heel up is off and heel down is on.
 
Now that I'm delving into the editor manual (which I didn’t initially know about) I'm realizing the possibilities. My PBC/6X continues to impress in what I can accomplish with it - but I'm just an amateur guitar player so sometimes it's a little slow going for me.

Thanks so much for the detailed response!
 
Back
Top